Hello everyone, today I am paying attention to an interesting topic, which is about the maintenance cycle of jaw crusher, so I have sorted out an answer to the maintenance cycle of jaw crusher, let"s take a look.
1. Daily maintenance and maintenance of jaw crusher
Daily maintenance: Regularly shut down the jaw crusher to check the machine. Any stone crushing equipment should pay attention to regular shutdown of the jaw crusher when turning on and off the machine to check the wear inside the machine, such as the wear degree of the center feed pipe, cone cap, upper and lower flow channel linings of the impeller, circumferential guard plate, and wear-resistant block. Replace the parts with more serious wear immediately. Repair these parts and pay attention to the weight, model and size of the replacement parts. They must be replaced according to the original part parameters.
The main engine suddenly stops (also known as "stifling"): This may be due to the blockage of the discharge port, resulting in obstruction of discharge. The solution includes clearing the blockage to keep the discharge unobstructed; adjusting or replacing the V-belt to ensure the normal transmission system; and checking and adjusting the voltage of the workplace to ensure that it is within the working requirements of the main engine.
The maintenance of the jaw crusher drive belt should not be ignored. Regularly adjust the tightness of the belt to ensure that it is evenly stressed. When dual motors are used, the triangular tapes on both sides must be grouped and matched to keep the length of each group similar. Once the transmission belt is found to be severely worn, it must be replaced immediately. Lubrication is the guarantee for the healthy operation of mechanical parts.
Always pay attention to the timely lubrication of the friction surface to ensure the normal operation of the machine and extend its service life. The grease used in this machine should be determined according to the location of use, temperature and other conditions. Generally, calcium-based, sodium-based or calcium-sodium-based grease can be used. Before using the jaw crusher, when installing and debugging it, it must be debugged strictly in accordance with the instructions for use, and the equipment must be fully inspected.
So far, the above is the editor"s introduction to the maintenance cycle of the jaw crusher. I hope that the introduction of 1 point about the maintenance cycle of the jaw crusher will be useful to everyone.